Transform an ordinary plant pot into a stunning upcycled candlestick with this sustainable DIY project. Perfect for adding a warm, festive touch to your home this Christmas!

Tools, Utilities, and Materials

Tools

• Cordless jigsaw (UniversalSaw 18V-100) with wood jigsaw blade
• Cordless two-speed combi drill (AdvancedImpact 18) with bit holder and bit set
• Bit holder and bit set
• Cordless multi-sander (PSM 18 Li) with sanding sheet set
• Forstner bit (15mm)
• Wood drill bits (3mm and 7mm)
• Metal drill bit (4mm)

Utilities

• Clamps for securing materials

Materials

• Plant pot (approx. 16x15cm)
• Beech rods (22 x 1000mm and 6 x 1000mm)
• Copper T-pieces (4x)
• Screws (4x 4 x 25mm)
• Washers (4x 4.3 x 15mm)
• Superglue
• Protective equipment (gloves, hearing protection, goggles, dust mask)
• Pencil, ruler, measuring tape, and set square

Sustainable Candlestick DIY: Upcycle Your Way to a Cozy Winter

The darker, colder months are perfect for transforming your space into a warm, inviting retreat. Rather than buying new decorations, why not embrace the charm of upcycling? This step-by-step guide will show you how to transform a simple plant pot into a stunning, sustainable candlestick to light up your holiday season.

Measure and Prepare the Pot

Setting the foundation for your upcycled masterpiece

1. Wrap the rim of your plant pot with painter’s tape to protect its surface.
2. Use a measuring tape to determine the pot's circumference, then divide it by the number of candleholders (four in this case).
3. Mark these points evenly around the pot, ensuring they are about 18mm from the rim.
4. Drill the four marked holes using a 4mm metal drill bit, securing the pot with clamps to keep it steady.

Cut and Size the Wooden Rods

Precision cuts for a flawless fit

1. Use the cordless jigsaw to cut four 15mm and four 160mm pieces from the 22mm beech rod.
2. From the 6mm rod, cut two pieces approximately 21cm each. The exact length may vary depending on your pot size.
3. Secure the rods on your workbench using clamps for clean, controlled cuts.

Drill Holes for Assembly

Prepping your materials for smooth construction

1. Drill 3mm holes in the center of each 15mm rod segment using a wood drill bit.
2. For the 160mm rods, drill 1cm-deep holes 2cm from one end on two rods. On the other two, drill 3cm from the edge.